| Author |
Message |
kuyaglen
Forum Ambassador
1st Lieutenant
|
| What kind of rivets are these? |
 |
From my Lian-Li PC-V1100A Plus II
On this link there are 12 kinds. They are flat unlike the rivets I drilled out from my Super Lanboy.
-Thank you.
|
|
| Thu May 17, 2007 1:57 pm |
|
 |
JeepMcMuddy
Has 0 internets
2nd Lieutenant
Posts: 815
Location:
LANcouver, WA |
|
|
|
Looks like a standard steel rivet, but it may be something OEM.
|
|
| Thu May 17, 2007 2:54 pm |
|
|
kuyaglen
Forum Ambassador
1st Lieutenant
|
|
|
| Those are "Countersunk" rivets. You'll have to search specifically for "countersunk" to find the right ones. |
Thank for your help everyone.
|
|
| Thu May 17, 2007 3:26 pm |
|
|
markkleb
Modder Extrodinare
1st Lieutenant
|
|
|
Sorry I just saw this thread, they are 1/8" alum flat head rivets.
They are a lot harder to find than reg alum rivets so i just sand the tops a touch after I install them. most of the time regular aluminum rivets work just fine the way they are.
|
|
| Sun May 20, 2007 3:53 pm |
|
|
SgtHunter
Colonel (Staff)
Posts: 1745
Location:
Seattle WA |
|
|
|
their flat top, and i believe installed from the inside so you may also need a low profile rivet gun to get in close enough to the walls.
_________________
-nu fi boboc-
|
|
| Sun May 20, 2007 4:15 pm |
|
|
kuyaglen
Forum Ambassador
1st Lieutenant
|
|
|
After removing everything that was screwed in and assesing the rivet situation, it would of been 1 step forward and 2 steps back in the long run.
|
|
| Sun May 20, 2007 4:39 pm |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
Design by Spork and
Offbeat Hosting
© 2009 PDXLAN
|
|
